The common construction methods for topcoat mainly include rolling and spraying. Rolling is to apply the paint evenly on the surface by using a roller, which is suitable for large-area wall or floor coating. Spraying is to spray the paint on the surface by using a spray gun, which is suitable for occasions where uniform coverage and uneven surface are required.
Rolling construction method
The specific steps of rolling construction are as follows:
Base surface treatment: Make sure the base surface is clean, dry, free of oil and dust. If the base surface has cracks or is uneven, it needs to be repaired and leveled.
Roller preparation: Select a suitable roller, usually a wool roller, and ensure that there are no lumps or impurities on the surface of the roller.
Paint preparation: Stir the topcoat thoroughly and dilute it if necessary to avoid clogging the roller.
Rolling operation: Start from one end of the wall, roll the roller horizontally, and then roll it vertically to cover the entire area. Note that the force of the roller should be even to avoid leaving roller marks.
Drying and sanding: After the coating is dry, lightly sand it with sandpaper to ensure a smooth surface12. Spraying construction method
The specific steps of spraying construction are as follows:
Surface treatment: Same as rolling, make sure the surface is clean, dry, free of oil and dust.
Spray gun preparation: Select a suitable spray gun, adjust the pressure of the spray gun and the size of the nozzle to ensure that the paint can be sprayed evenly.
Paint preparation: Stir the topcoat thoroughly and dilute it if necessary to avoid clogging the nozzle.
Spraying operation: Starting from one end of the wall, keep the spray gun at an appropriate distance from the base surface (usually 20-30 cm) and spray the paint evenly. Pay attention to controlling the speed and strength of the spraying to avoid dripping or accumulation.
Drying and inspection: After the coating is dry, check whether the surface is uniform and make repairs if necessary.







